Autel Support Communities
Autel Support Communities
Welcome, Guest     Sign in
Communities > Diagnostics > USA Cars > Not able to communicate with the ECU.
Not able to communicate with the ECU.

1974 Views 3 Replies Latest reply: 2017-06-03 20:27:27


  •   Level 2   
    (19) points

    2017-06-03 03:16:49
     
     I'm working on a 2002 Mazda Protege5. I had to replace both O2 sensors. At some point somebody cut the plug off the UP stream sensor. With everything but back together I plugged the 906BT into the OBD port but i get a message that the transmitter cannot communicate with the tablet. It can not read the VIN or talk to the ECU at all.
     Dose this mean the ECU is bad. The car will not run. I'v checked all fuses and relay's. 

     The car ran befor I satarted doing the work to it.

     Oil pan was replaced
     New O2 Sensors 
     New wheel bearings

    The only thing I can think of is the O2 sensor is misfired but I don't think that should keep the car from starting.

    Any suggestions are appreciated.  
    Reply

  •   Level 2   
    (19) points

    2017-06-03 04:34:06
      I also tried to use the USB cord to connect the tester to the tablet. Still nothing.
    Reply

  •   Level 7   
    (862) points
    SmogTech87

    2017-06-03 06:29:20 (Reply to:)

    I know you say you check all fuses. Can you double check the engine fuse 10A behind left kick panel. Is for the main relay and O2 sensors. 
    Reply

  •   Level 2   
    (19) points

    2017-06-03 20:27:27 (Reply to:SmogTech87)
     
    That was it. Thank you for the help
    Reply
1
  Total1 Pages
Last Post Next Post Go to original post Reply to original post
Related links
Top users
Online users
Search Communities